To avoid accidents resulting from tripping over loose speaker cables and to prevent the speakers from falling, fix the speaker cables to the wall, etc. Secure placement or installation is the owner’s responsibility. YAMAHA shall not be liable for any accident caused by improper placement or installation of speakers. CONSUMER PRECAUTIONS...
After unpacking, check that the following items are contained. Front speakers x 2 (NS-AP9500S) Surround speakers x 2 (NS-AP9600S) Non-skid pads for Surround speakers x 2 UNPACKING Center speaker x 1 (NS-AP9600C) Fasteners for the center speaker x 2 Speaker cable x 1...
Stand mounting the front speakers You can use the supplied speaker stands SPS-9500T for table top installation. For assembly instructions, please refer to the SPS-9500T owner’s manual which can be found in the SPS-9500T box. Wall mounting the front speakers The front speakers may also be hung on a wall, utilizing the key holes on the rear of the speakers.
Page 5
Attaching the non-skid pads to the surround speakers Place the satellite speakers on a sturdy, vibration-free surface, such as a well-built stand. Attach the included non-skid pads to the bottom of the surround speakers to prevent the speakers from slipping. Wall mounting the surround speakers 4-1/2”...
Page 6
Positioning the center speaker Place the center speaker on top of the TV, on the floor in front of the TV, or inside the TV rack so that it is stable. When placing the speaker on top of the TV, put the provided fasteners at four points on both the bottom of the speaker and on top of the TV to prevent the speaker from falling.
CONNECTIONS TO THE RECEIVER CONNECTIONS Check to make sure that the receiver has been turned off before making any speaker connections. Connect the (+) terminal of the receiver to the (+) terminal of the speaker. Connect the (–) terminal of the receiver to the (–) terminal of the speaker. Reversing polarity (+/–) will result in unnatural sound reproduction.
This speaker system consists of front, center and surround speakers. — Front speaker placement should be separated by a distance of 6–10ft. If they are placed too close together, there will be a reduction in the stereo effect. Conversely, If placed too for apart, the so called “middle- omission”...
Type Acoustic suspension Speaker Front Quad 4” High Compliance Pulp cone and Rubber Surround + 3/4” soft dome tweeter Center 3” woofer x 2 + 3/4” soft dome tweeter Surround 3” woofer x 1+ 1/2” balanced dome tweeter Frequency Range Front 100 Hz - 40,000 Hz Center...
Page 10
YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CA 90620 http://www.yamaha.com/yec Phone: 1-800-492-6242 P/N 430042 Printed in China...