Table of Contents
Advertisement
DME-N Network Driver Settings
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
In order for the computer to recognize the DME device(s), it is necessary to register the IP address and device
name of the DME device that is the Device Group Master.
1
Connect the DME device(s) to the computer as
described on
page
2
Double-click [Start] ➞ [Control Panel] ➞ [DME-N
Network Driver] to open the DME-N Network
Driver dialog box.
3
Click the [Advanced Settings] button to open the
"Advanced Settings" dialog box.
DME devices connected to the network can be
automatically detected via this dialog box.
4
Enter the IP address range over which you
would like to automatically detect connected
DME devices in the [Detect from] and [Detect to]
fields, and click [Start].
Automatic DME device detection will begin.
5
When automatic DME device detection has
finished, check the [Add] box of the DME device
DME Setup Manual
8, and turn the DME power on.
that is to function as the Device Group Master,
and click [Add to Device List].
The "Advanced Settings" dialog box will close and return
to the "DME-N Network Driver" dialog box.
n
If the IP address was not automatically detected,
register the DME device manually
6
Select the DME unit that is to function as the
Device Group Master from the Target Device
List, enter the Device Name and Device Port No.,
and click the [Apply] button.
Device Name
Displayed as the port name in DME Designer.
Device Port No. (MIDI port number)
Set to "1." "2" is also available for DME64N/24N devices.
7
Click the [Save and Close] button to close the
dialog box.
(page
20).
11
- Quick Links:
- Software Installation
Hide quick links:
Advertisement
Table of Contents
