Installing Fibers - Huawei OptiX RTN 980 Quick Installation Manual

Radio transmission system v100

Hide thumbs Also See for OptiX RTN 980:

Table of Contents

Installing Fibers

Precautions

CAUTION

When installing or maintaining fibers, do not look into the optical port without eye protection. See Figure 1.

Coil up the inter-office fibers on the ODF and then route them into the cabinet. Do not coil up external fibers

in the cabinet.

NOTE

When routing fibers, take proper measures to avoid any damage to fiber connectors

After installation of the fibers, place protective caps on to the idle optical ports, and place fiber caps on to the

idle fibers. See Figure 2.

Figure 1

NOTE

For a closed corrugated pipe, take protective measures and then route fibers into the corrugated pipe. For an

open corrugated pipe, route fibers into the corrugated pipe and then take protective measures.

After routing fibers into a corrugated pipe, wrap PVC insulation tapes around the cuts of the corrugated pipe.

Do not feed a large number of fibers in a corrugated pipe. It is recommended that you feed not more than sixty

2 mm diameter fibers in an open corrugated pipe and not more than twenty 2 mm diameter fibers in a closed

corrugated pipe (See Figure 3).

The corrugated pipe needs to be routed into the cabinet for approximately 10 cm (See Figure 4).

Figure 3

Figure 2

Fiber w ith a short

protective tube

Pluggable optical module

Figure 4

Fiber cap

Dustproof cap

10 cm

Table of Contents

Show Quick Links

Table of Contents