Program Running Time - Siemens SINUMERIK 828D Manual
Milling with sinumerik mold-making with 3- to 5-axis simultaneous milling
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
General information on workpiece production
2.11.2 Program running time
To gain an overview of the program running time and the number of machined workpieces, use
the Times/counters functions
Pressing the softkey the first time shows how long the program has already been running
every further start of the program, the time required to run the entire program the first time and
the remaining time are displayed
program has been completed in percent on a progress bar
The running times can be displayed block-by-block/non-modally and saved
times determined by the simulation are shown with a blue background. After the first processing,
the actually determined times are shown with a green background. The Settings softkey is used
to configure whether the running times should be displayed and saved.
When a program is executed for the first time, its progress is estimated based on the program
size and the actual program offset; this means it can differ from the actual running time.
5
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling
.
1
. In addition, you can follow how much of the current
3
4
2.11
2
.
. The running
5
.
6
1
2
3
4
6
. At
65
Advertisement
Table of Contents
