Table of Contents
Advertisement
Available languages
Available languages
Caution for Use and Maintenace
♦
Wire Clamp Unit
(1) When the wire residue builds up in the wire clamp:
Remove the wire clamp unit from the torch body, and
then use the high pressure air to blow the wire residue
off from the hole of the wire guide. If the wire reside
still remains, remove the cylinder to clean the hole
from the top side.
(2) How to replace the wire guide
(a) Remove the cylinder (17).
(b) Remove hexagon socket setscrews (21), (22) and
(23) at the fixture (18).
(c) Pull out the stopper (19) from the top side of the
fixture (18). (The stopper (19) has a machined flat
surface. Check the orientation of the surface.)
(d) Pull out the wire guide (20) from the power cable
side, and replace it with a new one
(e) Insert the stopper (19) from the top side of the fix-
ture (18). Make sure to place the groove of the
stopper upward so as to match the machine flat
surface of the stopper (19) and the stopper fasten-
ing screw of the fixture (18).
(f) Fasten the hexagon socket setscrew (M6) (21) so
that the height of the stopper (19) becomes the
same as before it was removed.
• Insert the 2 mm diameter gauge into the wire
path.
Adjust the hexagon socket setscrew (21) so
that the gauge and the stopper (19) touch.
• Apply the removable anti-loosening agent;
THREE BOND 1401B, to the hexagon socket
setscrew (21).
(g) Fix the stopper (19) with the hexagon socket set-
screw (M4) (23). Apply the removable anti-loosen-
ing agent; THREE BOND 1401B, to the hexagon
socket setscrews (22) and (23).
(h) Reinstall the cylinder (17).
14
No.
Part name
17
Cylinder
18
Fixture
18-1
Nut cover
19
Stopper
20
Wire guide
21
Hexagon socket setscrew
22
Hexagon socket setscrew
23
Hexagon socket setscrew
24
Elbow union
25
Spacer
26
O-ring
OM1105050JE03
- Quick Links:
- 保守パーツ / Parts List
Hide quick links:
Advertisement
Table of Contents
