GE SBSD137 Installation Instructions Manual page 2
Hide thumbs
Also See for SBSD137:
- Installation instructions manual (12 pages) ,
- Installation instructions manual (36 pages)
Advertisement
Available languages
Available languages
2 PREPARE THE PEDESTAL
Pull the
A
drawer out
as far as it
will go.
Remove screws
B
from drawer
slides. Slide
drawer out of
the base and set
aside.
Do not remove
C
the foam blocks
on the top of the
pedestal.
FOR DRYERS ONLY:
Locate the 4 support pads from the parts
D
package. Each pad has 2 protrusions that fit
into the holes on top of the pedestal. Press the
rubber pads into each set of corner holes on
the top of the pedestal as shown.
NOTE: The support pads should be installed on
the dryer only. DO NOT INSTALL THESE PADS ON
THE WASHER PEDESTAL.
Installation Instructions
2
3 INSTALL THE PEDESTAL
TO THE WASHER OR DRYER
Place the pedestal against the bottom
A
of the unit. Check to be sure the drawer front
is at the front of the unit.
Align the holes in the pedestal with
B
the holes in the bottom of the unit.
Use a Phillips screwdriver to install
the 4 screws through the pedestal
Slide the pedestal toward the unit,
C
until it is aligned front to back. Use an
8 mm socket wrench to securely tighten the
screws.
Advertisement
