Table of Contents
Advertisement
CHAPTER 5 MECHANICAL CONSTRUCTION
3.
Removing the Buffer Roller
Assembly
1) Remove the finisher controller PCB. (See
I-C-1.)
2) Remove the feed drive unit. (See I-B-2.)
3) Take out the screw [1] and remove the guide
support plate assembly [2] to slide out the
harness leads [3] towards the buffer roller
assembly side.
4) Remove the front cover. (See I-A-4.)
5) Remove the screw [4] and take out the guide
support plate assembly [5]. Then remove
the buffer roller assembly [6].
5-12
[1]
[2]
Figure 5-120
[4]
[5]
Figure 5-121
[3]
[6]
Advertisement
Table of Contents
Troubleshooting
