Setting
Display
*1
IP Address
or
*2
Host Name
Port No.
*3
Camera Name
*1 In IPv4, set 4 numbers (0—255) and 3 periods, such as "192.168.0.253". Note that
"0.0.0.0" and "255.255.255.255" are not available.
In IPv6, set the host name.
*2 Enter ASCII characters for the host name (see page 190). Note that [Space], ["], ['], [#],
[&], [%], [=], [+], [?], [<] and [>] are not available.
Enter 1—255 characters.
*3 Enter ASCII characters (see page 190) or characters from other languages (1—15
characters for a 1-byte character and 1—7 characters for a 2-byte character). Note that
[Space], ["], ['], [#], [&], [%], [=], [+], [?], [:], [<], and [>] are not available.
Note
•
If your camera will only be accessed on your local network, use each
camera's local IP address and port number.
•
If you intend to access your camera from the Internet, you must use each
camera's host name (global IP address) and the port number.
4.
Click [Save] when finished.
•
The new settings are saved.
•
The Multi-Camera Setup page is displayed.
•
Check this box to enable the camera.
•
Set an IP address or host name to enable the camera.
•
Set a port number (1—65535).
•
This camera name is displayed only on the Multi-Camera
page.
Description
Operating Instructions
149