Table of Contents
Advertisement
Chapter
2
System Components
Figure 2–13 shows the output opto wiring for non-isolated inputs.
FIGURE 2–13.
GPIO OUT COM
GPIO x
See Note
GPIO IN COM
GPIO IN COM typically connected to ground.
1.
Caution
The maximum current that can pass through the optoisolators is 50 mA.
Non-isolation setup can cause damage to the SIMATIC HawkEye™ 1600T if
excessive voltage is applied to the optoisolators.
2-16
GPIO Output Opto Wiring (Relay and PLC Inputs)
15-30V
SIMATIC HawkEye™ 1600T Smart Camera Guide
GPIO OUT COM
15-30V
GPIO x
Input
See Note
GPIO IN COM
Rev. 1E, Nov 2007
PLC
GND
Advertisement
Table of Contents
