Table of Contents
Advertisement
4 OPERATION
(2) After completing the above setting, click the
Close
button.
On the [ET.NET SYSTEM] or [[S10V] ET.NET] window, the setting and the
display method vary depending on whether the ET.NET module is installed or not
as shown in the following table.
Installation
status
Installed
Not installed
4.3.3 Route information setting
In the SV.LINK, the communication through a router is not supported. Any route information
setting is not required.
IP address
Subnet mask
Settable
(The contents of
(The contents of
setting are
displayed.)
Settable
(The contents of
(The contents of
setting are
displayed.)
OK
button. To cancel the setting, click the
NOTICE
Route information Physical address
Settable
Settable
(Button is
setting are
displayed.)
displayed.)
Settable
Not settable
(Button is not
setting are
displayed.)
displayed.)
4-10
Can be
referenced.
(Physical address
is displayed.)
Cannot be
referenced.
(FFFFFFFF is
displayed.)
Advertisement
Table of Contents
