Product Overview; Controls - Toro Groundsmaster 360 Operator's Manual
4-wheel drive multi-purpose machine
Hide thumbs
Also See for Groundsmaster 360:
- Service manual (497 pages) ,
- Operator's manual (60 pages) ,
- Installation instructions manual (8 pages)
Table of Contents
Advertisement
Product Overview
Controls
Become familiar with all the controls before you start
the engine and operate the machine.
Traction Pedal
The traction pedal
(Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move rearward. The ground
speed depends on how far you press the pedal. For
no load, maximum ground speed, fully press the pedal
while the throttle is in the F
To stop the machine, reduce the foot pressure on
the traction pedal and allow it to return to the center
position.
1. Parking brake
2. Brake pedal
Brake Pedal
Use the brake pedal with the brake-pedal latch to
engage and disengage the parking brake
7). To stop the machine, release the traction pedal
and allow it to return to the center position. You can
use the brake to assist in stopping the machine in an
emergency situation.
Tilt-Steering Pedal
To tilt the steering wheel toward you, press the foot
pedal down, pull the steering tower toward you to
the most comfortable position, and release the pedal
(Figure
7). To move the steering wheel away from
7) controls the forward and
position.
AST
Figure 7
3. Tilt-steering pedal
4. Traction pedal
(Figure
you, press the foot pedal and release it when the
steering wheel reaches the desired operating position.
Key Switch
The key switch has 3 positions: O
and S
(Figure
TART
1. InfoCenter
2. Power-takeoff (PTO)
switch
3. Engine-speed switch
4. Steering selector switch
Engine-Speed Switch
The engine-speed switch
change the engine speed. By momentarily tapping
the switch, you can increase or decrease the engine
speed in increments of 100 rpm. Press and hold the
switch to set the engine speed directly to high or low
g197397
idle, depending on which end of the switch you press.
Power-Takeoff (PTO) Switch
The power-takeoff (PTO) switch starts and stops the
attachment
(Figure
Power Point
The power point provides a 12 V power supply for
electronic devices
14
, O
FF
N
8).
Figure 8
5. Power point
6. Key switch
7. Deck-lift switch
(Figure
8) has 2 modes to
8).
(Figure
8).
/P
,
REHEAT
g026098
Hide quick links:
Advertisement
Table of Contents
