Advertisement
9. Protocol options
Use this option to select the method the AL-1116 reader sends
data to the panel.
Wiegand. Smart Card data is transmitted in the Wiegand
protocol (default). When user cards are programmed,
the AL-1623 programmer sets the number of bits (26
or 27).
Magnetic stripe. The reader sends data to the panel in a
32-bit magnetic stripe card format.
10. Card beep
Use this option to enable (default) or disable the beep sounded
when a card is badged at the reader.
11. Option card
Use this option to enable (default) or disable the use of reader
configuration cards at the AL-1116 reader. If you wish to prevent
modification of the reader setup by configuration card, you
should disable this option.
12. Last card
Use this option to display the number of the last card badged at
the AL-1116 reader. The format shows the facility code and the
ID number.
Offline mode
If the unit has power available, but loses communication with the
panel, the unit will go into offline mode. In this mode, all LEDs
will flash at the slow rate and the LCD will display System
Fault. This condition may be caused by the following:
• The unit is set to an address that is not polled by the panel or
4 door/elevator controller DGP.
• The D+ or D- wire is disconnected.
5
Advertisement
