Table of Contents
Advertisement
7368 ISAM ONT BGW320-505 Product Guide
7
8
9
10
11
12
13
14
15
Issue: 01
Release 06.02.00b | October 2019 | Edition 01
Connect a telephone to the RJ-14 POTS port.
Contact your service provider for details, especially if you have an alarm system.
Connect the fiber optic cable with the SFP adapter into the SFP connector. Figure
the location of the fiber optic connector.
Danger — Fiber cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Warning — Be careful to maintain a bend radius of no less than 1.5 in.
(3.8 cm) when connecting the fiber optic cable. Too small of a bend radius
in the cable can result in damage to the optic fiber.
Install the power supply according to manufacturer specifications.
Note — Observe the following:
•
Units must be powered by a Listed or CE approved and marked
limited power source power supply with a minimum output rate of
12VDC, 4A.
Power up the unit by connecting the power cable; see Figure
input.
If applicable, use the WPS button to connect additional Wi-Fi devices to the ONT.
i
If applicable, use the WPS button to connect additional Wi-FI devices to the ONT.
ii
Press the WPS buttons to change the status of the Wi-Fi Protected Service.
Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368 Hardware and
Cabling Installation Guide.
Activate and test the services; see the 7368 Hardware and Cabling Installation Guide.
If necessary, reset the ONT.
i
Locate the Reset button on a BGW320-505 indoor ONT as shown in Figure 6.
ii
Press the Reset button for less than 10 seconds to reboot the ONT.
Press the Reset button for 10 seconds to reset the ONT to its factory defaults.
STOP. This procedure is complete.
3FE-47753-AAAA-TCZZA
Replace an BGW320-505 indoor ONT
6
for the location of the power
6
shows
45
Hide quick links:
Advertisement
Table of Contents
