• Adjustment procedure
1. Make a print by the punch mode and check the horizontal registration position of the punch hole.
<Standard>
• 2/4 Hole Puncher Unit
2 holes: L3=108.5 ± 1.5mm (A3/A4) / 99.7 ± 1.5mm (11"×17"/LTR)
4 holes: L3=28.5 ± 1.5mm (A3/A4) / 19.7 ± 1.5mm (11"×17"/LTR)
• 2/3 Hole Puncher Unit
2 holes: L3=73 ± 1.5mm (LGL/LTRR)
3 holes: L3=31.5 ± 1.5mm (11"×17"/LTR) / 40.5 ± 1.5mm (A3/A4)
• 4 Hole Puncher Unit
L3=92.5 ± 1.5mm (A3/A4) / 83.7 ± 1.5mm (11"×17"/LTR)
2. Enter the following service mode to adjust the horizontal registration position of the punch hole.
- (Lv.1) SORTER > ADJUST > PNCH-Y
When the setting value is changed by 1, the punch position L3 shifts by 0.1mm.
+: L3 becomes larger (The punch hole shifts toward rear.)
-: L3 becomes smaller (The punch hole shifts toward front)
NOTE:
Adjustment range: -25 to 25
However, the adjustable range is from -3 to 15 when the setting value of "(Lv.1) SORTER > OPTION > PUN-Y-SW" is 0.
3. Make a print by the punch mode and check the horizontal registration position of the punch hole. When the punch
horizontal registration position is not the standard, adjust by repeating from the step 2 again.
Punch Feed Direction Position Adjustment
When the punch hole position in the feed direction is not the standard, adjust the punch feed direction position.
<Rear>
Delivery
direction
L3
<Front>
46
5. Adjustment