DRM-7000, DRM-AF751, DRM-AL751, DRM-AH721, DRM-PW701
How to Install the Additional Power
Supply Unit (DRW-PW701)
1
Remove the lower left side panel. (four screws)
2
Hang up the Additional Power Supply Unit to hooking
screws and tighten the four screws (BBZ30P060FMC).
2
×2
3
Connect a connector. (for DC output)
4
Insert a connector. (for power supply of Fan Motor)
5
Connect a connector. (for AC input)
6
Tighten the two screws (accessory parts, PMB40P080FMC)
to fix the earth lead wire and the chassis.
3
4
7
Install the lower left side panel. (four screws)
140
2
6
5
Moving the Carriage Base Up and
Down Manually
1. Open the Front Door.
2. Remove the Side Panel, located at lower-right viewed from
the front.
3. Rotate the Pulley with your fingers clockwise to move the
Carriage Base downward, and counterclockwise to move it
upward.
Caution: If the Front Door Switch is set to ON while the power
is on, the Motor Shaft will start rotating.
×2
For Shipping Stopper Screw of the Carriage
Base
For safety, when moving the unit, fix the Carriage Base by
the shipping stopper screws.
Pulley
Carriage
Base
upward
Carriage Base
downward