Advertisement
1-4. Removing and Installing the DCP
Board Assembly
Removal
1. Open the inside panel assembly. (Refer to Section 1-3.)
2. Disconnect the coaxial cable from the connector
(CN10) of the DCP-38 board. (When the CBK-SD01
is installed, disconnect the coaxial cable from the
connector (CN1) of the DIF-147 board.)
n
To disconnect the coaxial cable, do not attempt to
disconnect it by pulling the coaxial cable with force.
Be sure to hold the plug and disconnect the cable.
3. Remove the screw (B2.6 x 5) and the filter cover.
4. Disconnect the board-to-board connector that comes
from the DCP-38 board, and open the CN-2437 board
in the direction of the arrow.
CN-2437 board
Board to
board connector
DCP-38
board
B2.6 x 5
CN-2437
board
Filter cover
CBK-MB01
DCP-38 board
CN10
Coaxial cable
OK
Hold the plug
to remove
Do not attempt to
NG
remove by pulling
the plug.
1-4. Removing and Installing the DCP Board Assembly
5. Remove the harnesses from the connectors (CN1, CN3
and CN4) of the VA-228 board.
6. Remove the two screws (B2.6 x 5).
CN4
CN3
Harness
CN1
VA-228 board
7. Open the board lever in the direction of arrow A, and
disconnect the board-to-board connector that is
connected to the MB-1032 board.
8. Raise the DCP board assembly about 10 mm in the
direction of arrow B, and align the recessed portion of
the DCP-38 board with the protruded portion of the
board holder.
DCP board
assembly
Board-to-board
connector
MB-1032 board
VA-228 board
B2.6 x 5
Board holder
Board lever
A
B
Board
A
holder
Recessed
portion
DCP board assembly
1-3 (E)
Advertisement
