Table of Contents
Advertisement
BATTERY REMOVAL INSTRUCTIONS
(FOR DISPOSAL AND RECYCLING)
Batteries must not be removed by the consumer. At end of product life, only an authorized
recycler may safely remove batteries by using the following steps.
IQOS 2.4P Pocket Charger (A1503):
Step 1: Open IQOS Pocket Charger and remove IQOS Holder
Step 2: Insert a small tool into left top side of IQOS Pocket Charger plastic cover, unclip
and remove
Step 3: Disconnect red battery connector from PCB
Step 4: Unscrew 2 x PCB securing screws and remove plastic chassis
Step 5: Remove battery and dispose according to local regulations
Hereby, Philip Morris Products S.A. declares that IQOS 2.4P is in compliance
with the essential requirements and other relevant provisions of Directive
2014/53/EU.
The
official
Declaration
of
Conformity
may
be
found
at:
www.pmi.com/declarationofconformity
IQOS 2.4P Model A1503 operates within the 2.402 – 2.480GHz frequency band with a
maximum RF output power below 10.0 dBm.
Designed and manufactured under the authority of Philip Morris Products S.A., Quai
Jeanrenaud 3, 2000 Neuchâtel, Switzerland.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc.
and any use of such marks by Philip Morris Products S.A. and its affiliates is under license. Other
trademarks and trade names are those of their respective owners.
© 2018 Copyright Philip Morris Products S.A.
- Quick Links:
- Start Heating
Hide quick links:
Advertisement
Table of Contents
