This chapter describes the FL312 module startup procedure.
5.1 Startup Procedure Flow
6F8C1067
Chapter 5 Startup
START
Set node number with mode address
switch at bottom of module.
Install FL312 in prescribed I/O bus slot.
Connect MAU external power supply and
shielded ground wire of AUI cable to
terminal block.
Connect communication cable.
Turn on MAU power and then turn on the
controller power.
Set parameters with engineering tool.
Turn on the controller power once more.
Startup
Figure 5-1 Startup procedure
Then communication starts automatically
when the controller power is turned on
and RUN mode is entered.
13