Brother GT541 Install Procedures

Hide thumbs Also See for GT541:

Download this manual

GT541 INSTALL PROCEDURES

Machine Weight 220 lbs.

Crate is shrunk wrapped and strapped

1. Remove wrap and straps

2. Remove Top - first remove clips that holds top in place.

3. Remove card board internal sidings

• Remove thin cardboard top

• Remove accessory box

• Thin boards go on left and right sides of machine

• Thick boards go on Front and Back side of machine

• Remove box sides – surrounding of crate – first remove clips that hold

bottom in place.

• Remove plastic wrap from machine

4. Unscrew 4 screws from 2x2's that secures machines to pallet.

• Lift machine to table top—make sure that table top is strong enough to

hold machine for long period of time, machines weight is 220 lbs so if

table is not strong enough can warp top or break table in long term.

5. Remove 2x2's from bottom of machine when on tabletop.

• Replace screws back on machine after 2x2's have been removed. (Optional)

Install/Training

Follow Install Checklist for set-up

1. Inspect machine and room conditions

2. Level Machine (Pull platen out very slowly for level placement)

3. Open cover - Remove cardboard holder(s) from tubes and maintenance

station.

4. Lower rubber caps by rotating gear on the right side of the maintenance

station, slide head carriage to the center of the machine (this will give you

more room for installing heads)

Page 1 GT541 INSTALL PROCEDURES Machine Weight 220 lbs. Crate is shrunk wrapped and strapped 1. Remove wrap and straps 2. Remove Top - first remove clips that holds top in place. 3. Remove card board internal sidings • Remove thin cardboard top •...
Page 2 5. Use jig to make sure maintenance station has not shifted during shipping (see maintenance station adjustment) 6. Install heads • Use Rubber Gloves • First 20 machines will come with heads labeled for each color cartridge. • Hold heads from metal bracket when installing. •...
Page 3 13. Install printer driver (File Output) to customers PC without the printer connected to PC (follow on screen steps). 14. Connect USB cable to PC and Printer and power up the printer, the installation of the printer driver will auto start (follow on screen steps). 15.