Sony FVS-1000 Series Operation Manual page 29
Multi resolution film scanner
Hide thumbs
Also See for FVS-1000 Series:
- Maintenance manual (258 pages) ,
- Maintenance manual (138 pages)
Table of Contents
Advertisement
Item
OUTPUT
HD
OUTPUT FORMAT
OUTPUT SELECT
CHARACTER
TEST SG CONTROL Output of test signals is controlled.
SD1, SD2
OUTPUT FORMAT
OUTPUT SELECT
CHARACTER
TEST SG CONTROL Output of test signals is controlled.
LOG
OUTPUT SYSTEM
INPUT SOURCE
OUTPUT FORMAT
OUTPUT LENGTH
OUTPUT C.SPACE Select the output signal color space format for the LOG, 4:4:4
a) Function not available now
Setting(s)
Select the output signal format for an HD from among 60i, 50i,
48i, 30P, 24P, 25P, 30PsF, 25PsF, and 24PsF.
Select an output signal type for an HD from among 4:2:2, 4:4:4
(Y/C), and 4:4:4 (RGB).
Note
This page appears only when the BKFV-100/1 is installed.
Control characters superimposed on the HD signal.
ALL CHARA: ON/OFF
MESSAGE: ON/OFF
STATUS: ON/OFF
FCT: ON/OFF
TC: ON/OFF
CHARA POSI: H POSITION (move in the horizontal direction)
V POSITION (move in the vertical direction)
FORMATION (change the order of STATUS/
FCT/TC)
Set by turning three control knobs from the left.
CHARA TYPE: Select a character type; white with BG,
black with BG, white outlined, or black outlined.
Select from among OFF, H RAMP COLOR, H RAMP MONO,
V RAMP COLOR, V RAMP MONO, MULTI BURST,
100% COLOR BAR, 75% COLOR BAR, BLACK, and WHITE.
Select the output signal format for an SD1 or SD2 from among
525 60, and 625 50.
Select an output signal type for an SD1 or SD2 from among
4:2:2, 4:2:2:4, 4:4:4:4 (Y/C), 4:4:4:4 (RGB), 8:4:4H, 8:4:4V,
8:8:8 (Y/C)
a)
, and 8:8:8 (RGB)
Control characters superimposed on the SD1 or SD2 signal.
ALL CHARA: ON/OFF
MESSAGE: ON/OFF
STATUS: ON/OFF
FCT: ON/OFF
TC: ON/OFF
CHARA POSI: H POSITION (move in the horizontal direction)
V POSITION (move in the vertical direction)
FORMATION (change the order of STATUS/
FCT/TC)
Set by turning three control knobs from the left.
CHARA TYPE: Select a character type; white with BG,
black with BG, white outlined, or black outlined.
Select from among OFF, H RAMP, V RAMP, H SWEEP 12M,
H SWEEP 6M, V SWEEP, H 100% COLOR BAR, RED,
GREEN, and BLUE.
Select the output signal format for the LOG, Psf or P. The
output signal rate is automatically set with the film rate.
Select the input signal source for the LOG, MY (FILM G) or EN
OUT.
MY (FILM G): the signal output from the film gamma section
on the MY board.
EN OUT: the signal output from the EN board
Select the output signal format for the LOG (Only SMPTE is
available now.).
Select the output signal length for the LOG (Only 10 bits is
available now.).
(RGB) or 4:4:4 (Y/C)
a)
.
Mode Operation
No.
No.
F4
1
F4
1
F4
1
F6
1
(Continued)
27
Advertisement
Table of Contents
