Table of Contents
Advertisement
7. LOADING THE LABEL
7. LOADING THE LABEL
NOTES:
1. In the strip issue mode, you should use the printer with the side in which the model name
sticker is attached downward because the backing paper is issued from the bottom of the
printer.
2. In the strip issue mode, you can tear off the backing paper using the edge of the strip cover.
3. In the batch issue mode, you can tear off the backing paper at the perforation.
7.1 How to Load the Liner Backed Label Roll
1.
Place the printer on a level surface as shown below.
2.
To unlock the media cover, press the two cover release catches in the direction of the arrows.
3.
Open the media cover by pushing up the strip cover.
4.
Fully raise up the release lever, and then slide the paper guide (R) to the right.
Media Cover Release Catch
1
Strip Cover
Release Lever
3
2
Paper Guide (R)
E7-1
ENGLISH VERSION EO1-33014
7.1 How to Load the Liner Backed Label Roll
Media Cover
Media Cover
Release Catch
1
Fig. 7-1
Fig. 7-2
Hide quick links:
Advertisement
Table of Contents
