Siemens SINAMICS S120 Getting Started page 36

Starter commissioning tool

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Creating the Drive Project OFFLINE

11. Add the following components and data (as shown in Fig. 3-8):

– A new drive unit with the name SINAMICS_CU320

– A device: SINAMICS

– A type: S120 (6SL3...)

– Version V2.1

– Bus address (e.g. 8)

Note

The bus address must be the same as the PROFIBUS address set for the control

unit (see Fig. 2-2).

Section 3.2 shows you how to configure the drive unit and its components.

To add the components and data listed above, choose the relevant selection

fields and then choose Insert.

Fig. 3-8

Note

To insert other drives in the project, choose Insert.

3-36

Inserting the drive unit

SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 04.2004 Edition

Table of Contents