Table of Contents
Advertisement
C. Press the MENU button to exit.
4.4.2 ROP IP address setting.
Note: This must be the same as address set in the ERI - IP Adjust: - ROP Adjust menu. In this example
192.168.1.003. The Port setting should be 35200.
A. Press the MENU button, rotate the right hand knob to highlight 25 ROP IP SETTING, Press the right hand
knob to select it.
B. Using the knobs beneath the IP ADDRESS number that you want to change, set the address values
required.
C. Rotate the right hand knob clockwise to select the next set of IP ADDRESS values, using the knobs beneath
the number that you want to change, set the address values required.
D. Rotate the right hand knob clockwise to highlight the PORT number, using the knob beneath the PORT
number set the number to be 35200.
E. Rotate the right hand knob clockwise to select page 2/4 to set the SUBNET MASK i.e. 255.255.255.0
This must be the same as set in the ERI - IP Adjust menu.
F. Using the knobs beneath the SUBNET MASK number that you want to change, set the address values
required.
G. Rotate the right hand knob clockwise to select the next set of SUBNET MASK values, using the knobs
beneath the number that you want to change, set the address values required.
H. Rotate the right hand knob clockwise to select page 3/4 to set the DEFAULT GATEWAY i.e. 192.168.1.1
This must be the same as set in the ERI - IP Adjust: menu.
I. Using the knobs beneath the DEFAULT GATEWAY number that you want to change, set the address values
required.
J. Rotate the right hand knob clockwise to select the next set of DEFAULT GATEWAY values, using the knobs
beneath the number that you want to change, set the address values required.
K. Rotate the right hand knob clockwise to select UPLOAD (push). Press the knob below UPLOAD (push).
A popup will appear. Press the 3
4.4.3 CAMERA IP address setting.
Note: This must be set to match the IP address of the ERI. In this example 192.168.001.001 with the Port set
to 49152.
A. Press the MENU button, rotate the right hand knob to highlight 26 CAMERA IP SETTING, Push the right
hand knob to select it.
B. Using the knobs beneath the CAM1 IP ADDRESS number that you want to change, set the address values
required.
rd
knob from the left. Then reboot the ROP.
Advertisement
Table of Contents
