Advertisement
Quick Links
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Hot surface
instructions
This product is only suitable for well insulated areas or occasional use.
1. SAFETY
1.1.
GENERAL SAFETY
IMPORTANT: The LP13.V3 is a mobile, propane-fired, unvented, infrared space heater for commercial applications only. It is designed for use
with Propane cylinders of between 7kg to 15kg gas capacity. DO NOT use domestically.
WARNING! Use only in well ventilated spaces of more than 15m ³ to prevent an accumulation of dangerous combustion
gases.
DO NOT operate heater in basements or otherwise below ground level, in high rise flats, bathrooms or bedrooms.
DO NOT operate heater in leisure vehicles such as caravans and autocaravans.
WARNING! Heater will become very hot during use.
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
equipment.
Familiarise yourself with the application and limitations of the heater, as well as the potential hazards.
WARNING! Disconnect the heater from the gas supply before performing any maintenance.
Maintain the heater in good condition (use an authorised service agent).
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
WARNING! Keep all guards and holding screws in place, tight and in good working order. The guard on this appliance is to prevent risk
of fire or injury from burns and no part of it should be permanently removed. IT DOES NOT GIVE FULL PROTECTION FOR YOUNG
CHILDREN OR THE INFIRM. Check regularly for damaged parts. A guard or any other part that is damaged must be repaired or
replaced before the heater is next used. Avoid twisting the regulator's flexible tube. The tube should be inspected for damage regularly
and replaced if damage is found. Refer to the tube for its specification and length.
Keep gas hose away from heat, oil and sharp edges. Ensure that all connections are secure.
Keep the heater clean for best and safest performance.
Ensure the propane bottle is in a stable upright position before igniting the heater. DO NOT use with the bottle in any position other than
upright.
DO NOT use any fuel other than propane.
Ensure there are no flammable or combustible materials within 2 metres of the heater and that nothing, including walls, is less than
500mm from any surface of the heater.
DO NOT use the heater where there are flammable liquids, solids or gases such as paint solvents, etc.
WARNING! NOT to be used for the heating of habitable areas of domestic premises: for use in public buildings, refer to national
regulations.
WARNING! DO NOT use in basements or areas below ground level.
DO NOT move the heater when it is operating.
DO NOT use the heater for any purpose other than that for which it is designed.
DO NOT operate the heater if any parts are damaged or missing as this may cause failure and/or personal injury.
DO NOT adjust, or tamper with, the regulator.
DO NOT allow untrained persons to operate the heater.
DO NOT operate the heater when you are tired or under the influence of alcohol, drugs
or intoxicating medication.
When not in use disconnect from the gas supply and store in a safe, dry, childproof area.
In the event of a gas leak immediately close the bottle valve, extinguish any flame and
then place equipment in a well ventilated area, preferably outdoors, and away from any
heat sources (including strong sunlight). Rectify cause of leakage.
2. INTRODUCTION
Ceramic plaque type heater. Mounts on the rim of a propane cylinder. Adjustable output from
10,250 to 15,354Btu/hr. Supplied with 700mm of hose and 37mbar fixed regulator. Fully CE
approved. Gas bottle not included.
3. SPECIFICATION
Model No. . . . . . . . . . . . . . . . . . . . . . .LP13.V3
Fuel.
. . . . . . . . . . . . . . . . . . . . . . .Propane
Output. . . . . . . . . . . . . . . . . 10,250-15,354Btu/hr
Fuel Consumption. . . . . . . . . . . . . 0.220-0.330kg/hr
© Jack Sealey Limited
SPACE WARMER® PROPANE HEATER
10,250-15,354BTU/HR BOTTLE MOUNTED
LP13.V3
MODEL NO:
Original Language Version
fig.1
LP13.V3 Issue:4 (H,F ERP) -25/06/18
Advertisement
Related Manuals for Sealey Space Warmer LP13.V3
Summary of Contents for Sealey Space Warmer LP13.V3
- Page 1 LP13.V3 MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
- Page 2 6.3.2. Loosen and wind back the three screws in the clamp at the base of the heater support bracket and remove the heater from the gas bottle. 6.3.3. Fit the heater to a new gas bottle as in 5.1.2. and 5.1.3. Check for gas leaks as in 5.1.5. fig.2 Original Language Version © Jack Sealey Limited LP13.V3 Issue:4 (H,F ERP) -25/06/18...
- Page 3 Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 sales@sealey.co.uk...