Advertisement
Available languages
Available languages
7
Switch on the appliance by setting the timer to the
required tanning time (Fig. 3).
Note: For the correct tanning times, see section 'Tanning
sessions: how often and how long?'
When the set time has elapsed, the
,
timer automatically switches off the appliance.
-
If you want to tan more parts of your body
successively, you can set a new time before the set
time has elapsed.
-
By setting the timer again before the set time has
elapsed, you avoid the
3-minute waiting time which is necessary to allow
the tanning lamp to cool down.
8
Always unplug the appliance after use.
Tip: Keep track of the overall number of sessions you have
had on a piece of paper.
Cleaning
Always unplug the appliance and let it cool down before
you clean it.
Never use scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the
appliance.
1
Clean the outside of the appliance with a damp
cloth.
Do not let water run into the appliance.
2
Clean the UV filter with a soft cloth sprinkled with
some methylated spirits.
3
Clean the protective goggles with a moist cloth.
storage
1
Unplug the appliance.
2
Let the appliance cool down for 15 minutes before
you store it.
3
Wind the cord round the cord storage facility on
the back of the appliance (Fig. 4).
Replacement
lamp
The light emitted by the tanning lamp becomes less
bright in time (i.e. after a few years in case of normal
use). When this happens, you notice a decrease in the
tanning capacity. You can solve this problem by setting a
slightly longer tanning time or by having the tanning lamp
replaced.
Always have the tanning lamp replaced by a service
centre authorised by Philips. Only they have the
knowledge and skills required for this job and the
original spare parts for your appliance.
UV filter
Never use this appliance when the UV filter is broken,
damaged or missing.
Always have the UV filter replaced right away when it is
damaged or broken.
Always have the UV filter replaced by a service centre
authorised by Philips. Only they have the knowledge and
skills required for this job and the original spare parts for
your face tanner.
Protective goggles
Additional or replacement goggles, type HB071, can be
ordered under service number 4822 690 80123.
Environment
-
Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in
at an official collection point for recycling. By doing
this, you help to preserve the environment (Fig. 5).
-
The lamp of this appliance contains substances that
may pollute the environment. When you discard
the lamp, do not throw it away with the normal
422200261423
household waste, but dispose of it at an official
collection point.
guarantee and service
If you need information or if you have a problem, please
visit the Philips website at www.philips.com or contact
the Philips Customer Care Centre in your country (you
find its phone number in the worldwide guarantee
leaflet). If there is no Customer Care Centre in your
country, go to your local Philips dealer or contact the
Service Department of Philips Domestic appliances and
Personal Care BV.
guarantee restrictions
The tanning lamp is not covered by the terms of the
international guarantee.
Troubleshooting
If problems should arise with this appliance and you are
unable to solve them with the information below, please
contact the nearest Philips service centre or the Philips
Customer Care Centre in your country.
Problem
Solution
The appliance
Make sure the plug has been
does not start
properly inserted into the wall
socket.
There may be a power failure.
Check if the power supply works
by connecting another appliance.
The timer may not have been set.
Set the timer to the appropriate
tanning time.
The lamp may still be too warm
to restart. Let the lamp cool
down for 3 minutes before you
switch it on again.
Poor tanning
Perhaps you use an extension
results
cord that is too long or does not
have the correct current rating.
Consult your dealer.
Our general advice is not to use
an extension cord.
You may have followed a tanning
course that is not appropriate for
your skin type. Check the table
in section 'Tanning sessions: how
often and how long?'.
Perhaps the distance between the
lamp and your body is larger than
prescribed.
When you have used the lamp
for a long time, its tanning
capacity decreases. This effect only
becomes noticeable after several
years. To solve this problem, select
a slightly longer tanning time or
have the lamp replaced.
3/7
Advertisement
