Table of Contents
Advertisement
NOTE:
• If the warning is given, locate the remote
controller as soon as possible.
• Any attempt to start the engine will fail
while the warning is active. Blinking of
the immobilizer/keyless push start sys-
tem warning light in the instrument clus-
ter will indicate this condition. Refer to
"Warning and Indicator Lights" in the
"BEFORE DRIVING" section for details.
• Blinking of the immobilizer/keyless push
start system warning light should stop
shortly after the remote controller is
brought back inside the vehicle. If they
do not stop blinking, change the ignition
mode to "LOCK" (OFF) by pressing the
engine switch and then perform the
engine starting operation.
• Always keep the remote controller with
you as the driver.
Interior Workable Area for Engine
Starting, Ignition Mode Selection and
"Remote Controller Outside" Warning
(1)
EXAMPLE
57L31004
(1) Interior workable area
The "interior workable area" for these functions
is defined as all the interior spaces except for
the space above the instrument panel.
NOTE:
• Even when the remote controller is in the
"interior workable area", if it is in any of
the following conditions, you may not be
able to start the engine or select the igni-
tion modes, and the "remote controller
outside" warning may be given.
–The remote controller's battery is low.
–The remote controller is affected by
strong radio signals or noise.
–The remote controller is in contact with
or covered by a metallic object.
–The remote controller is in stowage like
the glove box or a door pocket.
–The remote controller is in the sun visor
pocket or on the floor.
• Even when the remote controller is outside
the "interior workable area", if it is in any of
the following conditions, you may be able
to start the engine or select the ignition
mode. The "remote controller outside"
warning may not be given at that time.
–The remote controller is outside the
vehicle but very close to a door.
–The remote controller is on the instru-
ment panel.
OPERATING YOUR VEHICLE
Parking Brake Lever
EXAMPLE
(1)
(2)
(3)
(1) To set
(2) To release
(3) To release
The parking brake lever is located between
the seats. To set the parking brake, hold
the brake pedal down and pull the parking
brake lever all the way up. To release the
parking brake, hold the brake pedal down,
pull up slightly on the parking brake lever,
push the button on the end of the lever
with your thumb, and lower the lever to its
original position.
For automatic transaxle vehicles, always
set the parking brake before moving the
gearshift lever to the "P" (PARK) position. If
you park on an incline and shift into "P"
before setting the parking brake, the
weight of the vehicle may make it difficult
79MH0-74E
54G039
3-8
- Quick Links:
- Instrument Cluster
- Specifications
Hide quick links:
Advertisement
Chapters
Table of Contents
