Tape Operation/Recording
IMPORTANT!
– Recording is permissible if copyright or
other rights of third parties are not
infringed upon.
– Recording is possible only in tape deck.
Preparation for recording
1
Load a recordable tape with the open side up
and the full spool to the right.
2
Prepare the source to the recorded.
DISC – load the disc(s)
TUNER – tune to the desired radio station.
USB – connect a compatible USB device.
When recording is in progress
1
Press SOURCE on the set or DISC, TUNER
or USB/AUX on the remote as desired source.
2
Start to play the selected source.
3
Press ● to start recording.
To stop recording
● Press 7 / 0 on the set.
Disc synchro recording
1
Select DISC source.
●
You can record programmed tracks in the order
you want.
2
Press ● to start recording.
Selecting another track during recording
1
Press ; to interrupt recording.
2
S / T
Press
to select another track.
3
Press ; to resume recording.
To stop recording
●
Press 7 / 0 on the set.
➜ Recording will stop.
IMPOTANT!
The making of unauthorized copies of copy-
protected material, including computer
programmes, files, broadcasts and sound
recordings, may be an infringement of
copyrights and constitute a criminal
offence. This equipment should not be used
for such purposes.
Tuning to radio stations
1
Press SOURCE on the set repeatedly or
TUNER on the remote until the desired
waveband is displayed.
2
Press and hold SEARCH
the button.
➜
The radio automatically tunes to a station
with sufficient reception.
3
Repeat Step 2 if necessary until you find the
desired station.
●
To tune to a weak station, press SEARCH
/
T
briefly and repeatedly until you have found
optimal reception.
●
For FM, extend, incline and turn the telescopic
antenna. Reduce its length if the signal is too
strong.
●
For MW, the set uses a built-in antenna. Direct
this antenna by turning the whol set.
Programming radio stations
You can store up to a total of 20 radio stations
in the memory.
Automatic programming
Press and hold PROG on the set for more than
three seconds to activate programming.
➜
All available stations are programmed.
➜
AUTO is displayed and available stations are
programmed in order of waveband.
Manual programming
1
Tune to your desired station (refer to "Tuning to
radio stations").
2
Press PROG on the set (PROG/ANGLE on
the remote) to activate programming.
➜
PROG flashes on the display.
3
Press í/ë to allocate a number from 1 to 20
to this station.
4
Press PROG on the set (PROG/ANGLE on
the remote) again to confirm the setting.
➜
PROG disappears.
5
Repeat the above four steps to store other stations.
●
You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
●
Press í/ë until the desired preset station is
displayed.
Tuner
S
/
T
and release
S
25