Yamaha HY144-D-SRC Firmware Update Manual page 8

Hide thumbs Also See for HY144-D-SRC:

Enlarged version

unselected, select this check box to allow access.

If the update manager is blocked by the Windows firewall,

the "Upgrade failed." dialog box appears.

8. Check the HY144-D-SRC to update.

Check the version of the update files and the

version number indicated in the HY144-D-

SRC line.

NOTE

If the HY144-D-SRC is not indicated, click [Refresh]. If it is

still not indicated, check whether the cable might be

disconnected or broken, whether the TCP/IP settings are

correct or not, whether the device to which the HY144-D-

SRC is installed is running or not, and whether the HY144-D-

SRC is recognized by the Dante Controller.

9. Click [Start].

The update operation will begin.

"Updating(n/m)" appears in the Status field

during updating. "Done" is displayed once

update is completed.

NOTICE

Update takes 2 to 4 minutes. During the update operation,

do not turn off the power to the device or disconnect the

cable. If update fails due to disconnection of the power

cable during the update, or due to other reasons, the device

may become inoperative.

NOTE

If the update is not completed after 5 minutes, or an update

failure indication appears, click X at the upper right corner

of Dante Firmware Update Manager to exit the program

without turning off the power of the device to which the

HY144-D-SRC Firmware Update Guide

Table of Contents

Show Quick Links