Chapter 4
4.1 Installation of Module
EH-IOCP can be installed next to the power supply module.
Install and uninstall the module after turn off the base unit power source.
4.2 Loading the Module
(1)Installing
(2)Removing
3 )
Installation and Wiring
2 )
1 )
1 )
2 )
1)
Hook the claw at the lower section of the
module to the hole in the base.
2)
Press in the upper side of the module
until it clicks.
Note 1: After loading the module, check to
make sure it does not come out.
Note 2: Load the power module at the
leftmost side of the base unit.
Note 3: Load the CPU module and I/O
controller to the right neighbor of the
power module.
1)
Push in the lock button.
2)
With the lock button pushed in, pull the top
of the module toward the front.
3)
Raise it toward the top and pull it out.
Note:
For the power module, pull it out while
pushing down the two lock buttons.
1
4-
Chapter 4 Installation and Wiring