ABB PositionMaster EDP300 Commissioning Instruction page 17

Digital positioner

Hide thumbs Also See for PositionMaster EDP300:

Table of Contents

Enlarged version

Fig. 16: Mounting the adapter on the positioner

1. Determine the mounting position (parallel to actuator or at

90° angle)

2. Calculate the rotational direction of the actuator (right or

left).

3. Move the rotary actuator into the home position.

4. Pre-adjust feedback shaft.

To ensure the positioner will operate within the operating

range (see chapter "General information" on page 13), the

mounting position as well as the home position and

direction of rotation of the actuator must be taken into

account when determining the adapter position on the

feedback shaft

. For this purpose, the feedback shaft

can be adjusted manually so that the adapter

attached in the correct position.

5. Place the adapter in the proper position on the feedback

shaft and fasten with threaded pins

threaded pins must be locked in place on the flat side of

the feedback shaft.

M10424-01

can be

. One of the

Fig. 17: Screwing the mounting bracket onto the positioner

1 Mounting bracket

Fig. 18: Screwing the positioner onto the actuator

NOTICE

After mounting, check whether the operating range for the

actuator matches the measuring range for the positioner, see

chapter "General information" on page 13.

PositionMaster EDP300 | CI/EDP300-EN Rev. C 17

M10421-01

Table of Contents