3.3.3
PRO devices, suitable for support arm and extension components
Requirement
● One of the following support arms or pedestal systems:
– Support arm or pedestal with a round tube end diameter 48.3 mm, suitable for the
– Support arm or pedestal with mechanical interface suitable for flange of the flange
– Support arm or pedestal with mechanical VESA interface, the corresponding Siemens
See also section "System components for PRO devices (Page 24)".
● The PRO device, all packaging components and protective films have been removed
● The lower cover of the PRO device from the accessory kit
● The following cables are fed through the pedestal or the support arm to which the device
is mounted:
– Protective conductor
– Power supply cable
– Data cables, e.g. USB, DVI and DisplayPort connecting cable
Procedure
The following description shows an example of how to attach the PRO device to a support arm system using the
optionally available Siemens flange mount. Mounting to a round tube that fits the opening of the PRO device is
performed in a similar fashion.
1. Loosen the 2 screws of the terminal
compartment cover and remove the
terminal compartment cover.
Industrial Flat Panel IFP1500, IFP1900, IFP2200, IFP1900 PRO, IFP2200 PRO, IFP1900 ETH, IFP2200 ETH
Operating Instructions, 07/2016, A5E31298376-AF
opening of the PRO device
mount and Siemens flange mount
adapter set and the Siemens flange mount
Recommendation: Route large connectors, for example DVI or PROFIBUS, and their
cables through the pedestal or support arm first.
Installing and connecting the device
3.3 Mounting the PRO device
49