Basic Network Settings Page; Advanced Network Settings Page - Bosch B426 Setup & Troubleshooting

Conettix ethernet communication module

Hide thumbs Also See for B426:

Table of Contents

Basic Network Settings Page

Used to configure the basic network settings used by the IP Communicator. See figure 6 below.

Figure 6 Basic Network Settings

 Note: Legacy TCP Automation Enable is used for Automation. Leave this setting=No when configuring

for Remote Programming Software and/or Reporting.



Legacy Panel Mode Disabled / Enabled: When enabled allows a single TCP connection with no security.

Legacy Panel Mode must be configured correctly for the IP Communicator to communicate with the panel. Set to

Enabled Only for the listed panels, set to Disabled for all other panel types. Note that the Enabled option is

greyed out when the address switch is set to one only compatible with Non-Legacy Panel types. (see table 1pg.5)



Port 77EE Configuration Enable: Select Yes to enable the network configuration port or No to disable the

network configuration port.



UPnP Enable: Enable Universal Plug and Play Yes or No.



HTTP Port Number: Select the HTTP Port number (1-65535) used for the module web server.



ARP Cache Timeout: When the module communicates with any device on a network, an entry is added to its

ARP table for each of those devices. The ARP Cache Timeout defines the number of seconds (1 to 600) before

the ARP table of the module is refreshed.

Figure 7 Advanced Network Settings

Table of Contents

Show Quick Links

Table of Contents

B420