Table of Contents
Advertisement
Configuring with Web Based Management
6.5 "System" menu
Description
The page contains the following boxes:
● Destination Address
Enter the IPV4, IPv6 address or the FQDN (Fully Qualified Domain Name) of the device.
● Repeat
Enter the number of ping requests.
● DNS Resolution
Select the IP address type in which an entered FQDN will be resolved.
– Auto
– IPv4
– IPv6
● Out Interface for IPv6
This selection is only required when the destination address is a multicast or a link local
address.
– "-" (factory setting)
– Select the relevant IPv6 interface.
● Ping
Click this button to start the ping function.
● Ping Output
This box shows the output of the ping function.
6.5.20
DCP Discovery
On this page you can select an interface and search for devices that are reachable via the
interface. The reachable devices are listed in a table. In the table you can check and adapt the
network parameters of the devices. To identify and configure the devices the Discovery
Configuration Protocol (DCP) is used.
Note
DCP Discovery
The function is only available with the VLAN associated with the TIA interface. You configure
the TIA interface in "Layer 3 (IPv4) > Subnets > Configuration".
216
In this mode, the IP address type is selected automatically.
The entered FQDN will be resolved in an IPv4 address.
The entered FQDN will be resolved in an IPv6 address.
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03
Hide quick links:
Advertisement
Table of Contents
