Universal Connector - Kenwood NX-5000 Series Common Function Reference
Hide thumbs
Also See for NX-5000 Series:
- User manual ,
- Manual (264 pages) ,
- Function reference (190 pages)
Table of Contents
Advertisement
11
11 EXTERNAL PORTS
EXTERNAL PORTS
The transceiver is equipped with function ports that can be programmed using KPG-D1/ D1N.
11.1
Universal Connector
Supported Models: Portable
For Portable, the transceiver is equipped with a function port that can be programmed for use with the 14-pin universal
connector located on the side of the transceiver. The Vibrator unit and GPS receiver unit can be connected to the transceiver
via the universal connector.
Assigning Functions to the Universal Connector
Pin 11 of the universal connector can be used with the following functions according to the user's purpose of use.
Function
When the AUX function is enabled by pressing the AUX key, or by pressing the Menu key to enter
Menu Mode and then selecting "AUX", the 5 V power source is supplied to pin 11 of the universal
AUX
connector. The transceiver stops supplying 5 V when the AUX function is disabled. A maximum
of 200 mA current can be supplied to pin 11.
If activation conditions of the vibrator are satisfied while the Vibrator function is enabled, the 5 V
Vibrator
power source is supplied to pin 11 at 500-ms intervals for 10 sec. The vibrator unit (KCT-48VU)
connected to the universal connector notifies a user by vibrating.
This configuration is applied when using external devices that always require a power source,
such as a speaker microphone and a headset.
The transceiver behavior varies as below depending on the configuration in Output Control by
SSW.
If the Output Control by SSW is configured to be enabled:
Always 5 V (high)
If the Output Control by SSW is configured to be disabled:
The 5 V power source is always supplied to pin 11 of the universal connector. This configuration
is applied when the KCT-51 is used. HRS Adapter can be used to easily connect audio accessories
HRS Adapter
or similar to the KCT-51. This configuration is also applied when an external device that always
requires a power source is used.
Note
Refer to
"Using Menu
Mode" for operations in Menu Mode.
0
If the Vibrator key is not configured while "Vibrator" is configured in Universal Connector Pin Number 11, the Vibrator
0
function is automatically enabled when the transceiver is turned ON.
Configuration using KPG-D1/ D1N
0
Configuring Universal Connector Pin Number 11 (
Connector)
0
Configuring Output Control by SSW to be enabled or disabled (
Always 5V (high))
Common FUNC (K, F)/Ver 2.20
Table 11-1 Available Functions to be Assigned to Pin 11
The 5 V power source is supplied to pin 11 if pin 1 (SSW) of the universal connector is low level.
The 5 V power source is always supplied to pin 11 regardless of the status of pin 1 (SSW) of
the universal connector.
Description
Transceiver Settings > Extended Function > Universal
Transceiver Settings > Extended Function >
CONTENTS
208
INDEX
- Quick Links:
- Table of Contents
- Using Menu Mode
Hide quick links:
Advertisement
Table of Contents
