Table of Contents
Advertisement
OPERATION
How to use the appliance
The following symbols will appear on the control
panel, next to each control knob :
Black circle: gas off
Large flame: maximum
setting
Small flame: minimum
setting
• The minimum setting is at the end of the anti-
clockwise rotation of the control knob.
• All operation positions must be selected between
the maximum and minimum position.
• The symbol on the control panel, next to the control
knob will indicate which burner it operates.
Automatic ignition with flame failure
safety device
The appliance is fitted with a flame failure safety
device on each burner, which is designed to stop
the flow of gas to the burner head in the event of the
flame going out.
To ignite a burner
• Press in the control knob of the burner that you
wish to light and turn it anti-clockwise to the
maximum position.
• If you keep the control knob depressed, the
automatic ignition for the burner will operate.
• You should hold down the control knob for 2~3
seconds after the flame on the burner has lit. If after
2~3 seconds the burner has not lit, stop operating
the device and open the compartment door and/
or wait at least 1 min before attempting a further
ignition of the burner.
• After this 2~3 second interval, to regulate the flame
you should continue turning the control knob anti-
clockwise until the flame is at a suitable level. The
operating position MUST be at a position between
the maximum and minimum position.
• To switch the burner off, turn the control knob fully
clockwise to the gas off position.
• In case of power failure, the burners can be lit by
carefully using a match.
OPERATION
15
Advertisement
Table of Contents
