Table of Contents
Advertisement
Error Status
You can display the error status in the display window.
Proceed as follows:
1
Press the MENU button to display the top display in
the display window.
2
f
Press the
bu tton.
ERROR STATUS appears.
3
Press the ENTER bu tton.
Error status and countermeasures
Display on the
Display on the
1st line
2nd line
REMOTE1 ERR DISCONNECT
CH.xx
REF ERR
FAIL CH.x
W/S ERR
FAIL CH.x
MAIN CPU ERR MEM ERR
BATT.VOLTAGE
LOW
BACKUP CPU
DOWN
ERR
PSU ERR
FAIL xx
NON xx
xx RUN HOUR
OVER
IXS-6600/6700
Word in "x"
Meaning
A/B1/B2/C
S-BUS line is disconnected.
A/B
Abnormal
. No reference video signal
detected despite the setting to
switch the crosspoint
synchronously with a reference
video signal.
. A reference video signal not
supported is detected.
c)
A/B
Abnormal
. An optional audio board is
attached, but an audio reference
(word sync) signal or reference
video signal is not input.
. A reference signal not supported
is input to the WORD SYNC IN
connector.
_
. Back up data for the main CA-65
board are destroyed.
_
. Voltage of the backup battery for
the main CA-65 board is
abnormal.
_
. There is a problem with the
backup CA-65 board.
a)
. There is a problem with the
A1/A2/B1/B2
power unit.
a)
. No power unit is installed.
A1/A2/B1/B2
a)
. The elapsed time of the power
A1/A2/B1/B2
unit is past the defined time for
periodic replacement.
The error status is displayed in order of importance.
The item for which the status is displayed can be
changed by pressing the
To move to the next layer above
Press the CANCEL button.
To return to the top display
Press the MENU bu tton.
Countermeasures
. Check the connection with a device
not responding, and connect it
correctly.
. Use a 75 Z terminator.
. Supply a reference video signal to
the REF IN connector.
. Cancel crosspoint switching
synchronized with a reference
video signal (set to ASYNC).
For details, refer to the System Setup
Manual (supplied).
. Supply an audio word sync signal
to the WORD SYNC IN connector.
. Supply a reference video signal to
the REF IN connector.
. Check the main CA-65 board (see
"Displayed Items" on page 2-1), and
download the backup data referring
the Installation Manual.
See "Status Indicators" on page 2-4.
. Check the MAIN CA-65 board (see
"Displayed Items" on page 2-1), and
replace the lithium battery of the
CA-65 board.
See "Status Indicators" on page 2-4.
. Check which is the main or backup
CA-65 board, and replace the
backup CA-65 board.
See "Status Indicators" on page 2-4.
. Check that the switch on the power
unit is set to ON.
. Check the power cable connection.
. Replace a defective power unit.
. Install a power unit.
. Replace the indicated power unit.
F
f
or
button.
2-5
Hide quick links:
Advertisement
Table of Contents
