Table of Contents
Advertisement
3.3.4
Distributed Integration into the SIMATIC S5
Integration on the
SIMATIC S5
3.3.4.1 Hardware Prerequisites
IM 308-C
S5-95U/master DP
IM 153-1
IM 153-2
CM35 Counter Module
(4) J31069-D0416-U001-A5-7618
Note
This section assumes that you have a knowledge of SIMATIC S5 and
COM PROFIBUS.
The CM35 module can be linked as distributed I/O to the SIMATIC S5 using
PROFIBUS- - DP.
The modular ET 200M I/O device is required to link the CM35 modules to
PROFIBUS- - DP. The SIMATIC S5 is connected to PROFIBUS- - DP with in-
terface IM 308- - C. Another method is to use a SIMATIC S5- - 95U/DP master
with integrated PROFIBUS- - DP interface.
Release 4 or later
Note
An FB 192 with release 3 can only be used with an IM 308- - C starting with
release 6!
When release status 2 of the FB 192 is used, all versions of the IM 308-C
can be used starting with release status 3.
Release 2 or later
The maximum transmission speed is 9600 Kbaud to 1.5 Mbaud, depending
on the length of the cable.
Prerequisites for the coupling are an IM 153- - 1 (MLFB no. 6ES7
153- - 1AA02- - 0XB0 or later) and CM35 modules (MLFB no. 6AT1
735- - 0AA01- - 0AA0, release status 4 or later)
Prerequisites for the coupling are an IM 153- - 2 (MLFB no. 6ES7
153- - 2AA01- - 0XB0, release status 2 or later) and CM35 modules (MLFB no.
6AT1 735- - 0AA01- - 0AA0).
CM35 modules (MLFB no. 6AT1 735- - 0AA01- - 0AA0, release status 4 or
later) are required for the IM 153- - 2 interfaces (MLFB no. 6ES7
153- - 2AA02- - 0XB0, release status 5 or later).
Commissioning
3-17
Advertisement
Table of Contents
