Extended Stock Removal Cycle - Cycle950 (Sw 5.3 And Higher) - Siemens SINUMERIK 840D Programming Manual
Cycles
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
4
03.96
04.00
4.10 Extended stock removal cycle – CYCLE950 (SW 5.3 and higher)
4.10
Extended stock removal cycle – CYCLE950 (SW 5.3 and higher)
The extended stock removal cycle is an option.
It requires SW 5.3 in the NCK and MMC.
Programming
CYCLE950 (_NP1, _NP2, _NP3, _NP4, _VARI, _MID, _FALZ, _FALX, _FF1, _FF2,
_FF3, _FF4, _VRT, _ANGB, _SDIS, _NP5, _NP6, _NP7, _NP8, _APZ, _APZA, _APX,
_APXA, _TOL1)
Parameters
string
_NP1
string
_NP2
string
_NP3
string
_NP4
int
_VARI
real
_MID
real
_FALZ
real
_FALX
real
_FF1
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
Name of the contour subroutine for the finished part contour
Label / block number start of finished part contour, optional
(this can be used to define contour sections)
Label / block number end of finished part contour, optional
(this can be used to define contour sections)
Name of the stock removal program to be generated
Type of machining: (enter without sign)
ONES DIGIT:
Values: 1...Longitudinal
2...Face
3...Parallel to contour
TENS DIGIT:
Values: 1...Programmed infeed direction X-
2...Programmed infeed direction X+
3...Programmed infeed direction Z-
4...Programmed infeed direction Z+
HUNDREDS DIGIT:
Values: 1...Roughing
2...Finishing
3...Complete
THOUSANDS DIGIT:
Values: 1...With rounding
2...Without rounding (liftoff)
TEN THOUSANDS DIGIT:
Values: 1...Machine relief cuts
2...Do not machine relief cuts
HUNDRED THOUSANDS DIGIT:
Values: 1...Programmed machining direction X-
2...Programmed machining direction X+
3...Programmed machining direction Z-
4...Programmed machining direction Z+
Infeed depth (enter without sign)
Final machining allowance in the longitudinal axis (enter without sign)
Final machining allowance in the facing axis (enter without sign)
Feedrate for longitudinal roughing
4
Turning Cycles
4-325
Hide quick links:
Advertisement
Table of Contents
