Identifier
Type
$P_EXTGG[n]
INT
$C_INC_PROG
INT
$C_I_NUM
INT
$C_J_NUM
INT
$C_K_NUM
INT
$P_AP
INT
$C_TYP_PROG
INT
$C_PI
INT
ISO Milling
Programming Manual, 06/09, 6FC5398-7BP10-1BA0
Description
Active G code of the external language
Bit pattern of all incrementally programmed addresses in a block with cycle call
Bit 0 = Address A
Bit 25 = Address Z
Bit = 1 address is programmed incrementally
Bit = 0 address is not programmed as absolute
Cycle programming: Value is always 1 if Bit 0 is set in $C_I_PROG.
Macro programming: Number of address I programmed in the block (max. 10).
For description refer to $C_I_NUM
For description refer to $C_I_NUM
Polar coordinates 0 = Off, 1 = On
Bit pattern of all programmed addresses in a block with cycle call
Bit 0 = A
Bit 25 = Z
Bit = 0 Axis is programmed as INT
Bit = 1 Axis is programmed as REAL
Program no. of the interrupt routine that was programmed with M96
Data lists
D.3 Variables
185