Table of Contents
Advertisement
3.2 Use of Controls – Fig. 3.2(a) to (f)
Page 1
Frame 1
Frame 2
Frame 3
Return from
Frame 4
any frame
Fig. 3.3(a) Advancing to Next Page
Frame 1
Advance to
next Frame
Frame 2
Frame 3
Frame 4
Fig. 3.3(b) Moving Between Parameters
Parameter Value
Note. Continued pressure on the
switches causes the rate of change of the
displayed value to increase. To make small
adjustments operate the switches momentarily.
Fig. 3.3(c) Adjusting a Parameter Value
Parameter X
Y
Z
Note. Continued pressure on the
switches causes the rate of change of the
displayed value to increase. To make small
adjustments operate the switches momentarily
Fig. 3.3(d) Selecting a Parameter Choice
Page 2
Frame 1
Frame 2
Frame 3
Page X
Adjust
and
Select
and
3 DISPLAYS & CONTROLS
Lift/Lower pen on alternate operations
Note. If 'Auto Pen Drop' is selected in the Set
Up Chart Page, BASIC CONFIGURATION LEVEL,
the pens automatically return to their operating
positions after a five minute delay.
Fig. 3.3(e) Lifting/Lowering the Pens
Information. The
the Set Up Function Keys Page, ADVANCED
CONFIGURATION LEVEL.
Acknowledge any alarm
Auto-tune
Pen lift/lower
Profile ramp soak
Local /Remote
Return operator to top of
Op. Page
Page X
Parameter 1
Parameter 1
Parameter 2
Parameter 2
Note. The
switch only returns the
instrument display to the start of the operating page
when at the top of any page.
Fig. 3.3(f) Selecting Programmable Functions
Auto/Manual switch – used for selecting
Automatic or Manual mode on alternate
operations. When manual mode is selected the
displays revert automatically to the process
variable values and control output or valve
position (if position-proportioning or boundless
motorized valve control is selected at Control
Type in the Set Up Control Page).
Fig. 3.3(g) Auto/Manual Switch Functions
switch is programmed in
or
.
Operating Page
Page X
Parameter 1
Parameter 2
7
- Quick Links:
- Input Error Messages
- Simple Fault Finding
Hide quick links:
Advertisement
Table of Contents
