16 Safety instructions
Safety labels
Safety labels are attached to the cabinet where necessary to alert personnel of potential
hazards when working on the equipment. The instructions on the safety labels must
always be followed, and the labels must be kept in a perfectly legible condition.
DANGER
Hazardous voltage inside!
Before servicing this unit:
1.Turn off and lock out facility power.
2. Wait 15 minutes for discharge.
Do not open door by force!
General safety in installation, start-up and maintenance
These instructions are for all personnel that install the drive and do maintenance work on
it:
•
If you select an external source for the start command and it is on, the drive will start
immediately after fault reset unless you configure the drive for pulse start. See the
firmware manual.
•
When the control location is not set to Local, the stop key on the control panel will not
stop the drive.
NOTICE
2UBA004820R0009