114. INSTALLATION
Install clutch by reversing removal procedure.
Some important steps will be explained below.
Flywheel
1) Tighten bolts to specification.
1.
Flywheel
Flywheel bolt
2.
3.
Special tool (Flywheel holder 09924-l 7810)
Input shaft bearing
Fig. 11-13 4*
2) Install input shaft end bearing to flywheel
using bearing installer (special tool).
1. Input shaft bearing
2. Special tool (Input shaft bearing installer 09925-98210)
Fig. 1 l- 13- 1
Clutch Disc and Clutch Cover
Using special tool (clutch center guide), install
clutch disc and clutch cover.
Tighten clutch cover bolts to specification using
special tool (Flywheel holder).
1.
Special tool (Clutch center guide 09923-38220)
2.
Clutch cover
3.
Clutch cover bolt
Special tool (Flywheel holder 09924-l 7810)
4.
Fig. 1 l-14
Clutch Release Bearing
Before installing retainer, apply grease to its
inner surface.
Fig. 1 I- 15 @ Grease (SUZUKI SUPER
GREASE "A',)
11-7