Sony DFP-R3000 Quick Start Manual page 8

Sdds player system, digital film sound reader/decoder

Hide thumbs Also See for DFP-R3000:

Note: Do not "hot plug" the Reader! The Reader gets its power through the cable

that connects it to the Decoder. Do not remove or install this cable while the Decoder

AC power is on. Doing so may cause damage to the Reader and void the warranty.

3.5 Decoder environment check.

The DFP-2500 Decoder is intended to be mounted in a rack chassis along with other

cinema equipment. However, it should not be mounted in close proximity to power

amplifiers or other equipment which may radiate strong magnetic fields or which give

° C (120° F

off high heat. Observe the ambient temperature limit of 50

) and if the

interior of the rack is excessively warm, provide more ventilation to lower the

temperature.

3.6 Wiring of other equipment.

This following is an illustration of the DFP-D2500 rear panel.

Note that these D-Sub connectors have metric (M2.5x.45) screw receptacles and require

mating connectors with metric screws. A kit of metric D-Sub connector screws is readily

available from most ordinary electronic part distributors. Avoid using standard D-Sub

connectors with 4-40 jscrews.

Cinema processors. Refer to the list of available Tech Notes for instructions on

correct audio and logic interconnections to other cinema processors. Note that Sony

connectors use the THX

pinout convention, but other equipment may not. Therefore,

pre-fabricated cables, or cables made with flat ribbon computer-type cable may not be

acceptable for use with the DFP-D2500.

Dfp-d2500