1.6. Monitor Connection
Make sure that the monitor is disconnected from mains and the power switches of
the computer and all attached devices are turned off before connecting the monitor.
-
Connect the signal cable plug to the videocontroller connector at the back of the computer.
-
Tighten the screws on the plug by hand.
-
Connect the power cord first to the monitor and then to a grounded power outlet.
1.4.1. If your monitor is DDC compatible (PC)
-
Do not use any adapter when connecting signal cable to your computer.
-
Do not extend the signal cable with extension lead. The DDC signals will not accept extended
cable.
1.4.2. If there is no DDC in your computer (PC)
-
Normally there is no need for adaptor when connecting signal cable to your computer.
-
Use MAC adaptor in signal cable when connecting the monitor to an Apple
Macintosh computer.
-
If the computer is equipped with separate display adapter card. It may have a standard
D ---SUB connector. In that case MAC adaptor is not needed.
Signal connector
Pin
Signal
1
--->
RV
2
--->
GV
3
--->
BV
4
< ---
ID2
5
6
RG
7
GG
8
BG
9
--->
10
LG
11
< ---
ID0
12
< ---
SDA
13
--->
Hs
14
--->
Vs
15
< ---
SCL
10
Red video
Green video
Blue video
(grounded)
Signal cable plugged/unplugged
Red ground
Green ground
Blue ground
DDC +5V
Logic ground
(Grounded)
DDC SDA
Horizontal sync., Composite sync.
Vertical sync.
DDC SCL
447R
5
1
6
10
11
15