Sony UP-D897 Instructions For Use Manual page 8

Digital graphic printer

Hide thumbs Also See for UP-D897:

Table of Contents

Enlarged version

Press the OPEN button to open the paper door.

Remove the label from the leading edge of the

paper, pull out about 15~20 cm (about 6~8 in.) of

the paper, and then set the paper roll in the paper

tray.

Note

To avoid exposing the paper to dust, dirt, etc.

always handle it carefully when removing from its

package and loading it in the unit. Paper exposed to

dirt or dust cannot be used for printing.

Load the paper with the printing side (heat

sensitive side) up. Printing is not possible if the

paper is reversed.

Loading Paper in the Unit

Remove label and pull

out 15 to 20 cm (about 6

to 8 inches).

Make sure that the paper is set

straight.

Close the paper door and press on it to shut it.

Notes

• Make sure that the paper is loaded straight. If it is

skewed, this could cause the paper to jam.

• If you did not pull out enough paper in step 3, press the

FEED button on the operation panel to feed some

more paper out of the unit without pulling out the

paper.

Table of Contents

Show Quick Links

Table of Contents

Up-d895