Table of Contents
Advertisement
RECEIVING GUIDELINES
Receiving Guidelines
This product may have been subject to road salt during transit. If so, immediately wash off all visible white residue from all exterior surfaces.
Upon receiving the product, check to ensure all line items are accounted for by referencing the delivery receipt or packing list.
Inspect each crate or carton for shipping damage before accepting delivery.
Alert the carrier if any damage is detected, do not refuse shipment.
The customer shall make notation of damage (or shortage of items) on the delivery receipt and all copies of the bill of lading which should be
countersigned by the delivering carrier. If damaged, immediately contact your manufacturer's representative. Any physical damage to the unit
after acceptance is not the responsibility of the manufacturer.
Handling Guidelines
Units are to be rigged and moved by the lifting brackets provided or by the skid when a forklift is used. Location of brackets varies by model
and size.
Handle in such a manner as to keep from scratching or chipping the coating. Damaged finish may reduce ability of unit to resist corrosion.
Unpacking Guidelines
Verify that all required parts and the correct quantity of each item have been received. If any items are missing, report shortages to your
local representative to arrange for obtaining missing parts. Sometimes it is not possible that all items for the unit be shipped together due to
availability of transportation and truck space.
Confirmation of shipment(s) must be limited to only items on the bill of lading.
Check control cabinet for field mounted sensors shipped loose.
Storage Guidelines
Units are protected against damage during shipment. If the unit cannot be installed and operated immediately, precautions need to be taken
to prevent deterioration of the unit during storage. The user assumes responsibility of the unit and accessories while in storage. The manu-
facturer will not be responsible for damage during storage. These suggestions are provided solely as a convenience to the user.
The ideal environment for the storage of units and accessories is indoors, above grade, in a low humidity atmosphere which is sealed to pre-
vent the entry of blowing dust, rain, or snow. Units designed for outdoor applications may be stored outdoors. All accessories must be stored
indoors in a clean, dry atmosphere.
Indoor Maintenance Guidelines
Maintain temperatures evenly to prevent condensation. Remove any accumulations of dirt, water, ice, or snow and wipe dry before moving
to indoor storage. To avoid condensation, allow cold parts to reach room temperature. Leave coverings loose to permit air circulation and to
allow for periodic inspection.
The unit should be stored at least 3½ in. (89 mm) off the floor. Clearance should be provided to permit air circulation and space for inspec-
tion.
Outdoor Placement Guidelines
The unit should be placed on a level surface to prevent water from leaking into the unit. The unit should be elevated so that it is above water
and snow levels.
Ensure sufficient support to prevent unit from settling into soft ground. Locate parts far enough apart to permit air circulation, sunlight, and
space for periodic inspection. To minimize water accumulation, place all unit parts on blocking supports so that rain water will run off.
Do not cover parts with plastic film or tarps as these cause condensation of moisture from the air passing through heating and cooling
cycles.
Due to our policy of continuous product innovation, some specifications may change without notification.
14
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Advertisement
Table of Contents
Troubleshooting
