ET-3600
Start Here
Read these instructions before using your product.
Nota para hispanohablantes/Note for Spanish speakers:
obtener instrucciones de configuración en español, consulte la Guía
de instalación en www.epson.com/support/et3600sp (requiere una
conexión a Internet).
1
Unpack
Note:
Do not open the ink bottles until you are ready to fill the ink
tanks. The ink bottles are vacuum packed to maintain reliability.
1
Remove all protective materials from the product.
2
Lift up the scanner unit and remove all protective materials
from inside the product.
Caution:
Do not touch the translucent part or ink tubes.
3
Lower the scanner unit.
2
Note:
gloves and place a sheet of paper or plastic under the ink tank when
you fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off
immediately with a damp towel to avoid permanent stains. If ink gets on
your clothes or belongings, it may not come off.
Warning:
Para
drink the ink.
1
2
French control
panel stickers
3
4
5
Fill ink tanks
This product requires careful handling of ink. Wear disposable
Keep the ink bottles out of the reach of children and do not
Open the ink tank unit cover, then remove the cap for the
black ink tank and attach it to its holder.
Unpack the black ink bottle.
Snap the bottle tip off, then remove the bottle cap.
Carefully remove the protective seal (avoid touching the ink
underneath the seal), then close the bottle cap tightly.
Caution:
Be sure to close the bottle cap tightly, or ink may leak.
Fill the tank using all of the ink in the bottle.
Note:
Refer to the color-coded sticker above the ink tank unit to
identify the color of each tank.
Caution:
Be sure to fill each tank with the correct color.
Carefully seal the bottle using the reverse side of the bottle
tip for proper disposal.