Recording/Editing; Notes On Recording; Useful Tips For Recording - Sony RCD-W10 Operating Instructions Manual
Cd/sacd players & changers: cd/cdr recorder/player
Hide thumbs
Also See for RCD-W10:
- Manual (51 pages) ,
- Operating instructions manual (35 pages) ,
- Service manual (100 pages)
Table of Contents
Advertisement
Recording/Editing
Notes on Recording
• You cannot record over existing material. The unit
automatically starts recording from the end of any
existing material.
• Make sure that the remaining recordable time on the
CD-R or CD-RW is longer than the playing time of
a source CD, especially if you want to record all the
tracks on the CD.
• If a message appears in the display, refer to
"Messages" on page 29.
• With the following kinds of CDs, you may
experience a reading failure or noise when recorded
to a CD-R or CD-RW.
– CD with adhesive labels attached to them
– Irregularly shaped CDs (for example, heart or star
shaped)
– CDs with printed text concentrated on one side
only
– Old CDs
– Scratched CDs
– Dirty CDs
– Warped CDs
• If the following occurs during CD playback or
recording, a reading error may occur or noise may
be produced in the recorded results:
– The disc tray or other part of the system is
bumped.
– The system is placed on an uneven or soft
surface.
– The system is located near a speaker, door, or
other source of vibration.
• Recording automatically stops if recording is
paused for more than about 3 minutes.
Note on a copy protection
Some commercial CD may contain a copy
protection code that will prevent the disc from
being recorded. In this case, "Cannot Copy"
and either "C12" or "C41" will appear
alternately in the display.
Do not move the unit or disconnect
the unit from power source in the
following situation. Recording may
not complete successfully.
• When "Finalize," "Unfinalize," "Erase," or "OPC"
appears in the display:
The unit is currently updating the table of contents
(TOC).
• When "PMA Writing" appears in the display:
The unit is currently updating the track information.
16
Useful Tips for Recording
When using the remote, set SELECT to CDR.
SELECT
Checking the remaining
recordable time on the CD-R
or CD-RW
Press TIME repeatedly.
• Each time you press the button while the unit
is stopped, the display alternates between
total disc playing time and remaining
recordable time on the CD-R or CD-RW
(page 9).
• Each time you press the button while
recording, the display alternates between the
recording time of the current track and the
remaining recordable time on the CD-R or
CD-RW (page 10).
SBM
TIME
TIME
Hide quick links:
Advertisement
Table of Contents
