Troubleshooting Guide - Sony 0 CDX-3160 Operating Instructions Manual

Fm/am compact disc player
Table of Contents

Advertisement

Troubleshooting guide

The following checklist will help you remedy the problems that you may encounter with your unit.
Before going through the checklist below, check the connection and operating procedures.
General
Problem
No sound.
The contents of the memory
have been erased.
Indications do not appear in the
display.
No beep tone.
CD playback
Problem
CD cannot be loaded.
Play does not begin.
CD is automatically ejected.
CD will not eject.
The operation buttons do not
function.
The sound skips due to
vibration.
Radio reception
Problem
Preset tuning is not possible.
Automatic tuning is not
possible.
The "ST" indication flashes.
Error displays
The following indications will flash for about five seconds.
Display
Cause
A CD is dirty or inserted upside
down.
The CD player cannot be operated
because of some problem.
If the above-mentioned solutions do not help improve the situation, consult your nearest Sony
dealer.
Actual total number:
Cause/Solution
•Adjust the volume with (+).
•Set the fader control to the center position for two-speaker
systems.
• The power cord or battery has been disconnected.
• The reset button has been pressed.
n Store the settings again into the memory.
Remove the front panel and clean the connectors. See "Cleaning
the connectors" (page 9) for details.
An optional power amplifier is connected and you are not
using the built-in amplifier.
The beep tone is muted (page 8).
Cause/Solution
Another CD is already loaded.
The CD was forcibly inserted upside down.
Dusty disc.
The ambient temperature is more than 50°C (122°F).
Press the 6 button for two seconds.
Press the reset button.
• The unit is installed at an angle of more than 20°.
• The unit is not installed in a sturdy part of the car.
Cause/Solution
• Store the correct frequency.
• The broadcast signal is too weak.
The broadcast signal is too weak.
n Use manual tuning.
•Tune in the frequency correctly.
•The broadcast signal is too weak.
n Set to the MONO mode (page 7).
Solution
Clean or insert the CD correctly.
Press the reset button or 6.
Sony CDX-4160/3160 (
EN
13
E
) 3-859-005-32(1)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdx-416Cdx-4160Cdx-3160

Table of Contents