Initial Setup
.
Figure 2-2: Connecting the G24
Connecting External Accessories
Replace the Developer Board cover and connect the following external connectors in the
sequence shown.
Power Supply
Caution:
Caution:
To Connect the Power Supply
1. Connect the supplied Wall adapter to the Wall Adapter Connector (J230)
8
G24
G24
MMCX
Internal
Screws
Connector
RF Cable
Before connecting the power supply, make sure that the Developer Board On/Off
switch (located in the rear of the board, as shown in
OFF
position.
When using the Wall adapter, make sure to insert it into the Power Adapter
Connector (J210) and not to the Mini-AB USB connector (J380), as shown in
Figure 2-3, on page
Developer's Kit
Internal
Antenna
Connector
External
RF Cable
External
Antenna
Connector
9.
Figure 2-3, on page
9) is in the
(Figure
2-3).
April 1, 2006